hello i searched for the topic but no avail

my question is how to properly install the relay onto the connector slide attachment on the junction box. i cannot figure this out...thanks

 

I couldn't figure it out either. I think I just left it hanging lol.

 

x2 we're pathetic

 

yep.. had the same problem , just get double sided foam tape or velcro put it on the relay and slap it on a clean area

 

x4.

 

hahaha...cool i thought im the only one having issues....i just used double sided tape just like you all said...thanks :D...my install is done...thanks again

 

haha yeah i helped my cousin install his and we just left his hanging also

 

the mounting tab on the VRD relay does not match the Toyota unit. therfore it will not hook in the same area that the Toyota version does.

 

not sure wt u guys r talkin about, i didnt leave anything hanging when i installed mine

 

Left mine hangin haha

 

Their speaking of the VRD fogs, they come with a relay which is basically a box with wires going in and coming out. They wondered what to do with it.

 

the little black box with the tab coming out of it with the circle in it? if its that, i put it under a bolt that was at the top of the compartment where u attached the 2 white pieces, not where the fuses are, but above it, the thing u pull out where the fog light switch goes with the places for switches, behind there and up a little is a bolt

i wish i had a pic, ill try to snap one tomorrow morning if i can before i leave, my camera is in my car anyways so ill try

 

let it hang.