Scionlife.com - Post pics of your Scion tC exhausts here!!!

Scionlife.com (https://www.scionlife.com/forums/)

- Scion tC 1G Drivetrain & Power (https://www.scionlife.com/forums/scion-tc-1g-drivetrain-power-1637/)

- - Post pics of your Scion tC exhausts here!!! (https://www.scionlife.com/forums/scion-tc-1g-drivetrain-power-1637/post-pics-your-scion-tc-exhausts-here-95508/)

Post pics of your Scion tC exhausts here!!!

Just like the topic says.

im up for this thread, i dont have an exhaust, i just took of the springs from my spring loaded bolts haha.. sounds good.

ooo i like this thread

^lol at your license plate..thats awesome

^^^wut exhaust is that...magniflow..?

Quote:

Originally Posted by insanetc

^^^wut exhaust is that...magniflow..?

i believe its ZPI's catback?

Quote:

Originally Posted by insanetc

^^^wut exhaust is that...magniflow..?

ZPI from the s-pipe all the way back

oh...thanks...i saw that style b4 an dsomeone said it was magnaflow..i like it though....

it says magnaflow on the actual can.

^^ wut do you have mirrors on your rear bumper...crazy shinny :rofl: ..nice exhaust

What is with all the big mufflers the magnaflow and zpi are ok. Im looking to get a exhaust but they are all crazy looking.

its cause your not looking in the right place.....

http://www.arkspeedracing.com/04_ON_...m1200-005d.htm

hmmm whats the hp gain on all of these exhausts?

Quote:

Originally Posted by WiCkEd_TrInI

hmmm whats the hp gain on all of these exhausts?

the catbacks will most likely be around 4-5whp while axleback may be 1-2whp

thanks.. so im gessin the ark is the best hp gain of all?

^^^ yeah tsudo FTW!!!! I want one so bad!!!

Custom duals... Flowmaster 60 series muffler with completly custom install.
http://a455.ac-images.myspacecdn.com...88c131fdce.jpg

^do you have any better pics? I can't see what's going on there.

looks like turns downs, nothing to see.

I will try and get some better photos for this thread, I took this one with my phone just as they were finishing the fabrication. For now, I will try to explain it... This is a Flowmaster muffler with an inlet and outlet on one end and an additional outlet on the opposite end. This allows for the muffler to be mounted going side to side. this allows one output to run from each side. We ran my outlet straight out to the sides and then dumped them at an angle from the outermost corners of the bumper. We used angle-cut 3" stainless tips and angled them to where the outlet is level with the ground. I hope this clears this up just a little.

anyone want to post up the new Greddy exhaust?

Quote:

Originally Posted by mad_vtak

https://www.wesellcarparts.com/custo...installed2.jpg

Megan Cat Back

that looks really good. i didnt know the megan exhaust is angled like that

Quote:

Originally Posted by FIREDOG

its cause your not looking in the right place.....

http://www.arkspeedracing.com/04_ON_...m1200-005d.htm

I was about to say it. I just ordered my dt-s last week. Should be here tomorrow! :nails:

Quote:

Originally Posted by VI_tC

https://pic16.picturetrail.com/VOL68.../220318109.jpg

i hate to tell u, but those arent exactly centered...

i actually think it is. the tips aren't centered in the holes but the holes are centered with the car. look at the scion emblem.