its cause your not looking in the right place.....

http://www.arkspeedracing.com/04_ON_...m1200-005d.htm

 

looks custom to me.

 

it is custom.

 

Draxas Header-back Exhaust

 

hmmm whats the hp gain on all of these exhausts?

 

the catbacks will most likely be around 4-5whp while axleback may be 1-2whp

 

thanks.. so im gessin the ark is the best hp gain of all?

 

$157.00 shipped Ebay Special! Number 1 exhaust

 

^^^ yeah tsudo FTW!!!! I want one so bad!!!

 

Custom duals... Flowmaster 60 series muffler with completly custom install.

 

^do you have any better pics? I can't see what's going on there.

 

looks like turns downs, nothing to see.

 

I will try and get some better photos for this thread, I took this one with my phone just as they were finishing the fabrication. For now, I will try to explain it... This is a Flowmaster muffler with an inlet and outlet on one end and an additional outlet on the opposite end. This allows for the muffler to be mounted going side to side. this allows one output to run from each side. We ran my outlet straight out to the sides and then dumped them at an angle from the outermost corners of the bumper. We used angle-cut 3" stainless tips and angled them to where the outlet is level with the ground. I hope this clears this up just a little.

 

anyone want to post up the new Greddy exhaust?

 

that looks really good. i didnt know the megan exhaust is angled like that

 

 

I was about to say it. I just ordered my dt-s last week. Should be here tomorrow!

 

 

i hate to tell u, but those arent exactly centered...

 

i actually think it is. the tips aren't centered in the holes but the holes are centered with the car. look at the scion emblem.