ok so im throwin 1 code...

thank god its not tune related lol (PTuning did good)

but whats wierd is that i had the weapon R antifouler on the car for about a week and it never threw a code...but on the ride home after the tune on the highway crusin at a perfect 14.8(lol) she popped on after about 150 miles

im thinking that the 14 hours of dyno time fried the secondary 02 sensor and thats why its throwin the code....

im thinking that the antifouler is working right since it never threw the cat below efficiency code....

so u guys think a P0136 is just a busted 02?

 

If it's a circuit malfunction, I'd think it would be wiring related. I'd test out the circuit before spending the ~$150 on a brand new sensor.

Also, I've never ran an anti-fouler and I've never thrown an O2 code or had any problems with my sensors.

 

hmm...what would the wiring issue be? loose connection somewhere?

 

Could be anything really, open, short, bad ground, loose connection. Get under there with a DMM and start checking voltages lol.

 

LOL i hate lil BS problems...freakin waste of time lol

but its better than real problems i guess lol

 

most of the time it will always go back to the sensor unless u burn or rub a hole in ur harness the odds of harness failure are very low from the factory most harness failures are caused by us ____ing with it lol....

 

so maybe my dezod exhaust burned the wires? ill have to jack it up tomorrow n look...

i dont even know where the secondary 02 plugs into....all i kno is where the primary plugs into lol

 

so maybe my dezod exhaust burned the wires? ill have to jack it up tomorrow n look...

i dont even know where the secondary 02 plugs into....all i kno is where the primary plugs into lol

 

wen you jack it up check straight up from were the 2econdary plug is and it plugs into a connector right there straight up from the plug,

 

Okay...wierdness....im drivin along and the code just clears itself....i hook up the scanner and its not even showing under pending codes......very interrrrrresting hmm

 

wth haha, wish mine just "disapeard" =/ haha blahh i need a tune! lsfkmlsdfkvml

 

I have a feeling that pretty P0136 code is gunna show up again tho lol. I dont have that kindaa luck haha

 

every 3xx miles I throw the same code P0172(running rich) after about 50 miles of driving.... it clear itself too.... I don't get it

 

mine always pops on and off when it pleases. it usually happens when i run it too hard for too long... i.e. canyon racing lol. i freaked out the first time, now i just learned to ignore it lol.

and i dunno about the odds of a harness failure being low lol. i left my car at home when i went to vegas because i was scared of running into problems on such a long trip and took our Sienna instead and that harness went out on me in vegas!! just my luck i guess!

 

hey I Rob..... I forgot to tell you.... alot of people where hating on you cause you got first place at the Rockland Toyota show...lol

 

ive got an extra o2 sensor i could sell ya cheap

 

boo! right after i posted my last comment on this thread my CEL light came on!!! grr! im glad i didnt post in a blown engine thread....with my luck who knows what could have happened! lol. i hope you get that problem resolved!

 

Haha wat a coinkydink hahaha

i guess ill have to get off my lazy azz and fix it or just get inspected in between CEL's lmao

 

haha i scanned it and it was just the no cats code so i was relieved.
yes get off your booty and find out exactly whats wrong with it!

 

Electrical tape works wonders! No, I'm not talking about using it on wires, just put it over your engine light on your dash! Problem solved!