I bored out my block 20 over to 89mm, how much psi u think i can run max with stock walls? i was told no higher than 18psi by my tuner, what do you think?

 

prolly 18 then if your tuner said that number

 

boost does not matter im tired of seeing people post this question. its about heat how much heat can the motor take before detonation begins to occur cooler denser air makes beter power with less strain on the motor. not to mention you got your stock block that only has liners in aluminum sleeves. so you weakened the sleeves that were in there....

 

^^ maybe u should make a sticky

 

Stock sleeves begin do distort around 550whp with or without detonation. .020 over will lower to 545whp lol. I wouldnt worry much about it unless ure turbo and fuel system will support atleast 500whp.

 

Boost is irrelevant as coryjames mentioned. I think stock sleeves can handle about 500 WHP on that bore size. Anything more than that is pushing it. I advise against ANY use of nitrous in this vehicle.

 

i agree, nothing much to add lol

 

hey guys how much boost can i run on a 4088r on stock internals lol and every one give me their fic maps

 

im confused with that post coryjames...... are u trying to degrade me and make a sarcastic comment to look cool?
if so u can stop entering my thread if u dont like. k thx.

 

Uuummm ok? Oh wait was that a joke?

 

 

 

no it wasnt a joke well about the fic maps and i was in the honda forums when i posted that and some guy was asking that and just got flamed lol


and a parting gift

http://www.youtube.com/watch?v=zDiR7UxI8Ow

vid of my car
http://www.youtube.com/watch?v=eyqUj3PGHv4

 

 

its called yes yes

 

Video of my car detonating.
http://www.youtube.com/watch?v=oHg5SJYRHA0

 

lol yes dance is way better then that lol

 

 

i hate you guys.