building a turbo set up (it has begun!!) pic on page 7!
the uego has a 0-5volt output (white wire i think, double check with uego instructions) that will need to be extended to the fic harness. you will connect this uego output to pin 18 of the 22pin connector (smaller connector). if using the universal harness and hardwireing the whole thing it will be the wire marked as "AUX IN", if using the pnp harness youll need to look at the 22 pin connector with the wire side of the connector facing you and clip facing up, pin 18 will be the 5th on the top row counting from left to right. (if you need the instructions for clarification i can email them to ya). if the pnp harness already has the wire in it then your in luck, if not youll need to take the universal harness and pull out a wire and pin out of the connector (pray those micro tabs dont break off) and slide in the pin/wire into the connector.
hope this helps
Thread Starter
Senior Member


Team Scionara
SL Member
Joined: Mar 2009
Posts: 1,230
From: Hazel Park, MI
When are you thinking about dyno tuning? I still need to get my setup tuned for high boost and if Dan is tuning urs the we could share the dyno time to save some cost. Let me know....
Thread Starter
Senior Member


Team Scionara
SL Member
Joined: Mar 2009
Posts: 1,230
From: Hazel Park, MI
i took a class at OCC to learn how to ride... and we used little tiny night hawk 250 and 125s in a parking lot. then from there i went to my sport bike. what a difference!




