You must've not done the right wires for the resistor mod.

well i did same as pictured... or maybe.. but i did 2times... didnt start..
or do i get wrong resistor ? is that can make problem ? was 2.2ohm..... well ill try again then tomorrow..

what?

dude, theres incorrect grammar that makes sense, and incorrect grammar that doesn't. you chose the latter. i have no idea what you said, granted it sounds like you aren't fluent in english, so i'll let it slide...but what?

Make sure you're counting the pins right... the pin locations are what's important.

yes sir! ill try it again tomorrow.... thx for the help!

2.2 ohm, wasnt it supposed to be 2.2K ohm? the K makes a huge difference!

anyway...bout time someone did a write up on this, nice job!

Maybe I'll do a write up on how to connect the UEGO for logging soon.

yeah i was stupid i bought the 2.2ohm but forgot the K haha well everything looks fine now very thx for the help guys! ill post some Dyno Result very Soon :bow:

I guess I'll do this today.. since I finally got off my ___ and bought the 2.2k ohm resistors yesterday. They've been sitting on my desk ever since.

Do you use the Crnk1 Mago or Magi +/-?

Do you use the Cam1 Mago or Magi +/-?

I guess I don't have the Boomslang harness...

We use CRNK MAGI and CAM MAGI

I got to looking at the pictures, and I'm using the supplied F/IC harness.

Here's the Crnk1 Magi +/- ( The green wires over my thumb)

https://i302.photobucket.com/albums/...s/IMG_1223.jpg

Heres the Cam1 Magi +/- (The yellow wires over my finger tips)

https://i302.photobucket.com/albums/...s/IMG_1226.jpg

Should have the same result as putting the resistors into the Boomslang harness right?

I got the DIY printed out and on hand for instant reference!

https://i302.photobucket.com/albums/...s/IMG_1219.jpg

hey garret you could have called me and asked....lol

just noticed your sig......lmfao

Yeah.. well... You were at work.

I just got the resistors on and about to crank it up!

It's a quick easy mod. It took me about 20 mins total.

well start it already!!!!!!!

rob this is awesome man!!!!!!!!!!!!!!!!! YOU ROCK! im gonna try to do this asap and see if this fixes my hick up im having ....

hey chrush... you can actually wire the aem uego to the fic?? hmmm i did not know that... lol.. im guessing you can use it in the AUX guage side and monitor your uego on the laptop correct???

Good news is that it cranked up.

thats the idea.......i haven't gotten it to work yet....i followed aem's instructions very closely but to no avail......i called aem about it and left a msg but no one returned my call....ill have to remember to call them while im at work i guess....on my lunch break of course :lalala:

I have the Uego hooked up to the FIC. You have to relocate a pin to use the AUX GAUGE INPUT (check wiring diaram) then calibrate it on the laptop.