can a stock head unit handle...
#1
can a stock head unit handle...
i have(plan to install) a jl audio 10w7powered by a jl audio 500/1 amp wired with a rockford fosgate 4 gauge single amp kit with a circuit breaker. and 2 pairs of mb quart dse 216 components. and i was wondering if the stock single disc head unit can handle it. in the near future im going to eventually get a screen. but as of right now i cant bare to drive without some bang, its been too long.
#2
hmmmmm........does the JL amp have high level inputs???? also, are you going to amp the component system??? if so, does/will that amp have high level inputs??? this would be an easier route to take rather than getting a line level converter......other than that....it should be ok untill you get a screen.....
#4
well....you don't NEED an amp....but it is a night and day difference with and without an amp on them......without an amp your components won't reproduce to their full potential.....and it doesn't matter what type of inputs it has it's is still a monoblock......high inputs means you use a splice from speaker wire instead of RCA's to get an audio input to the amp.....
#9
Originally Posted by SCI_TC_GUY
I've got JL VR components.....other good brands are CDT Audio, Boston, Diamond Audio, Focal, EDi, RE...
#11
eDi 6500's. Used to have Fanatic X's from RF, my roommate has JL XR's. Easily better than both of those component sets. But do amp them. I have an Eclipse 8443 and I ran them off HU power for a while...amped makes all the difference.
Also, for a vast improvement in your midbass....seal your doors and deaden them.
Also, for a vast improvement in your midbass....seal your doors and deaden them.
#13
Originally Posted by tC875
i see. anyone know anything about infinity kappas?
Thread
Thread Starter
Forum
Replies
Last Post
clickclickw00t
PPC: Interior / Electronics
2
02-18-2015 08:57 PM
wiltonhall
Scion xA/xB 1st-Gen ICE & Interior
2
01-28-2015 03:46 PM