Kenwood DNX6140 Question
10-17-2009, 08:27 PM
#1
Junior Member
Thread Starter
Join Date: Sep 2009
Location: FL
Posts: 8
Kenwood DNX6140 Question
Hello everyone,
I recently bought a 2006 tC and so far have been liking the car. What an upgrade from the 2001 cavalier I had been driving around. Anyway I bought a Kenwood DNX6140 so I could have Navigation, ipod connectivity, etc right in the dash. Anyway I also bought the PAC SWI-Jack for it so I could keep my steering wheel controls. Anyway it was confusing at first bought I finally got everything connected. The only problem that I am having is when I try to program the source button. The unit is not recognizing it at all so I could only program the volume and seek buttons. Has anyone else run into this problem or know why this would be happening?
Also, I recessed the unit a bit and the door closes but it is still pressing the volume **** on the unit. What is the best way to file down a little bit of the plastic on the door?
Thanks for any help.
I recently bought a 2006 tC and so far have been liking the car. What an upgrade from the 2001 cavalier I had been driving around. Anyway I bought a Kenwood DNX6140 so I could have Navigation, ipod connectivity, etc right in the dash. Anyway I also bought the PAC SWI-Jack for it so I could keep my steering wheel controls. Anyway it was confusing at first bought I finally got everything connected. The only problem that I am having is when I try to program the source button. The unit is not recognizing it at all so I could only program the volume and seek buttons. Has anyone else run into this problem or know why this would be happening?
Also, I recessed the unit a bit and the door closes but it is still pressing the volume **** on the unit. What is the best way to file down a little bit of the plastic on the door?
Thanks for any help.
Thread
Thread Starter
Forum
Replies
Last Post
