I did the instrument panel LED swap on my TC, but ive run into a problem. After settng all the needles on the gauges back to the correct position, whenever i plug it back into the dash harness (with the battery connected) all the needles plunge down out of position, im guessing from the current. So i then tried to reinstall with the battery disconnected and then reconnected it after the panel was in...same thing.

Is there something im doing wrong? Any help would be appreciated.

 

Ive also tried adjusting them after reconnecting. It started fine the first time,but the second time i started it they jumped out of alignment then when i shut the ignition off the went to below their starting points.