Easystreet rear install
#1
Easystreet rear install
I'm building something in my car that requires air lift to support the weight.
The design will completely cover access to the rear strut towers...
There are 3 nuts on each side of the car that need to be removed...
I cannot find anywhere how to install the rear kit but obviously I will need to install the rear suspension before covering it up.
Now some questions-
How does the easystreet kit install in the back?
Does it still use those 3 mounting locations?
If it does.. can the bolts be inverted so i can remove it if i have to without ripping this entire design out of my car i'm building?
The design will completely cover access to the rear strut towers...
There are 3 nuts on each side of the car that need to be removed...
I cannot find anywhere how to install the rear kit but obviously I will need to install the rear suspension before covering it up.
Now some questions-
How does the easystreet kit install in the back?
Does it still use those 3 mounting locations?
If it does.. can the bolts be inverted so i can remove it if i have to without ripping this entire design out of my car i'm building?
Thread
Thread Starter
Forum
Replies
Last Post
kleecker
Scion xB 2nd-Gen Suspension & Handling
3
01-09-2015 02:26 PM
PTUNING
PPC: Engine / Drivetrain
3
12-11-2014 08:09 PM
PTUNING
Exclusive Sponsored Sales
0
12-06-2014 03:58 PM
TheRedBox
Scion xA/xB 1st-Gen Drivetrain & Power
31
12-02-2003 04:53 PM