custom exhaust question
#1
custom exhaust question
I am having Inline Pro(Virginia) do my exhaust. I need help figuring out
1. what diameter exhaust piping to run.
2. is their any point to doing a custom axel back
3. I am trying to decide between the apexi N1 (60mm inlet/90mm tip)
4. or the HKS Hi-power (130mm canister/60mm inlet)
The whole point is to have an exhaust I like that is similar to the blitz nur(angled to the right)
Except i do not belive that the blitz would look proper on an 06(redesign of rear bumper)
The goal is to have the exhaust angled to the right, fitting snug, with the tip going no further out than the cut out of the bumper.
I would appreciate an guidence
(BSP 2006xa)
I plan on ordering from Hop Up Racing on Monday http://hopupracing.com/unmu.htm
1. what diameter exhaust piping to run.
2. is their any point to doing a custom axel back
3. I am trying to decide between the apexi N1 (60mm inlet/90mm tip)
4. or the HKS Hi-power (130mm canister/60mm inlet)
The whole point is to have an exhaust I like that is similar to the blitz nur(angled to the right)
Except i do not belive that the blitz would look proper on an 06(redesign of rear bumper)
The goal is to have the exhaust angled to the right, fitting snug, with the tip going no further out than the cut out of the bumper.
I would appreciate an guidence
(BSP 2006xa)
I plan on ordering from Hop Up Racing on Monday http://hopupracing.com/unmu.htm
Thread
Thread Starter
Forum
Replies
Last Post
CONCRETETC
PPC: Interior / Electronics
1
02-09-2015 08:05 PM
carid
Exclusive Sponsored Sales
0
02-09-2015 01:49 PM