I just fineshed these pulleys. The only thing difernt from the first batch is the color. All measurments are the same as stock. They just weigh 2lbs 6oz lighter. I am sure there is lighter out there but the lighter you go the thinner your inner wall the more chance of it warping under heat. Anyways hope u fine folk like them!

https://www.scionlife.com/gallery/?photo=51570
https://www.scionlife.com/gallery/?photo=51569

Ok thats preatty strange I used to be able to put images in my posts now I cant. Trippen!!
Let me know what you guys think, and yes that dyno was done as a before and after and yes you do get a increase in power. LOL

 

What was the actual horsepower gain from the pulley on the dyno?Are you going to be selling these in the near future?

 

I gained 3 hp/3tq at peak gaines and close to 2 at peak hp/tq. Sorry the dyno on my profile dosnt come in as clear as i would like. and yes i have 3 blue and 3 red for sale. I am curently working on the TC pulleys and XB wheel spacers to.

 

How is the installation? Am I going to need profesional installation? How much? Did you make these your self? Whats the company name? Can I ask more question? Has it gotten annoing yet?

 

Are these made for the xA? How much? Are they reliable like an agency pulley?

 

How much will they be? Also, how hard would it be to get one in a different color such as yellow?...

 

can you make me a underdrive power steering pulley, i need one about 2 inches smaller in diameter

 

Ok The instalation depends on your ability. I installed mine my sellf. I think alot of people get them installed by a profesional but I know what Iam doing so I do it my self. Yes I made them my self. I work at a machine shop and I made them on the CNC lathe and CNC mill. I do all the programing, run and check every part my sellf. As for reliability I have 10,400 milles on my pulley and have had not one problem with my belts or any thing. I will warenty my part for one year that it will not cause damage to your bellts, or flip them. LOL I will NOT warenty it not coming off and causing damage to any thing. Poor install is not my fault. My parts are balenced to less then a gram. As for differnt collors do you like the goldish collor of the one in my profile. I can get you one like that. I would like to get $90 for each one this batch. Next batch will be more I am sure T6 is going sky high. Can I make an underdrive powerstering pulley? Of course. If you want to get me the stock pulley and put some money down for material and such. Like I said though I am working on a couple other parts right now and its taking a little longer than I had hoped. The lathe is tied up on a big job. Damn!!

 

OHH, for the XA I am almost positive the XB and XA use the same engine so I would say yes they could be used on your crank.
Any more questions anyone. Feel free to hit me up!!
Ryan
West Coast Grit

 

exact same pulley for xA and xB

 

yah, they use the same engine, if I am wrong fill me in.