Anyone have this installed? If so, did you throw a CEL? How did you wire it up?

 

No I don't have one....but I was over at PLX last week checking out the gauges in person and they do look slick, it is nice that you can use one gauge hooked up to multiple sensors and toggle through them.

As for the CEL the gauge is a stand alone unit and does not mess with the car in any way you will not trigger a CEL.

Install guide http://www.plxdevices.com/Installati...UsersGuide.pdf

 

i'm not talking about the gauge. i'm asking about the wideband controller. supposed to replace stock narrowband and sensor and emulate narrowband to the ecu so that it won't throw a cel. i have it installed, but i am throwing cel p0031 which is for o2 sensor bank 1 heater. i have added 20 ohm 10 watt resistor across heater and ground wire and am still throwing cel. just frustrating cause i've tried wiring the resistors at ecu and at o2 sensor plug. decided to just have a 3rd bung welded on.