morningman

ok before any one says something i have already done a search
i am looking for a how to on installing dual halo headlights i have a pair coming in soon

thanks
morningman

squirrel

You'll have to take the bumper cover off to access the lower bolts that hold the headlight on.

WRxB

Yeah, If I remember correctly you take the bolts on the inner fenders out, next the grille out & undo the bolts behind the grille. You can tip the bumper down very carefully & access the lower & corner bolts. That is how I did mine.

If you are not comfortable with that you may want to remove all of the lower bolts as well & remove the whole bumper.

You will see, it is really simple :D

WRxB

Here refer to this post for help on the bumper

https://www.scionlife.com/forums/vie...=bumper+remove

Good Luck

morningman

ok thanks but i also need a little elp on how to wire it up

Thanks
Morningman

j0n

plug in play type just plug an the black an yellow wires are for the halo's and led's... u could hook them up with your turnsignal or use them with some other type of switch if u want... depends how u want to use them....

Big_Bird

if you want to hook them to a switch, what type of whire would you use and how would you run it to the consol?

morningman

i think ill wire the halos up to the parking lights because is it leagle to drive with just halos on
or if i wire it up to a switch i would use thisnspool of 18 4 i got
Thanks
Morninman

biancoxb

I am trying to hook it up to a switch with some 12 v wiring , but no clue where to begin, anyone have photos ? or some advice where to look ?

Grime

from the halos, run just about any gauge wiring, I believe around 18ga would be best, to the switch inside the cabin wherever you want to place it Then run some more wiring from the switch to your battery or active power wire or the battery, with a fuse. and ground the ground wires.