Seen this done before, and have been wanting to do this for a long time, finally got around to it. (I know, it needs a vacuuming!)


got the **** off Ebay. It was for a Mitsubishi, couldn't find one i liked for a toyota/scion. I had to drill it out to fit the post, and i cut a couple inches off the lockout shaft so it'd sit lower. Got the boot off ebay too, it's a cheapo, think i'm gonna change it later.

 

lookin good

 

Thanks. I changed it though, i put the boot over the silver bezel, instead of tucked in. and i think i'm going to go to a all black boot, not feeling the red stitching.

 

Looks good, not much of a choice for automatics

 

ive wanted to do this for awhile now, just to lazy haha, and i like my o/d switch, i could incorporate it in somehow tho i guess.

 

I'm wiring an OD switch on the side of the console, even though i've never switched it off in the two years i've had it.

 

Yea, I keep saying that the OD switch is what's keeping me from doing this, but I never actually use the OD switch.

 

Yeah, I was a little reluctant to snip the wires, but it's the only way to get the **** off. I didn't care for the factory OD switch on the **** anyway, my knee had a tendancy to hit it and switch it off.

 

yeah I always had that prob as well, I hated it.

I just relocated a button down in the corner of the center console at the base of the shifter base for the OD when I did my shifter.

It looks good by the way.

 

lol i have no business here, but you guys sure do say a lot of "yeah"





back to topic, looks good

 

looks very good!!