I was all excited until I saw the price,$200+

It looks like they fit XB's that have no side skirts.

Too bad, I want a mudflap solution to slinging slop on the side of my box.

The XB2 has a mudflap in the aftermarket, but we still do not. Unless you run with no side skirts.

Link:
http://www.newscionparts.com/product/?id=2737

 

This is not a Gen1 part so it won't fit.
I've seen generic ones adapted to xB1. Looked so-so.

 

Yea, that's for the 2nd gen.

 

too bad they did'nt make any for the 1 Gen. that would have been sweet. just keep searching...iam doing the same.

 

I saw a D.I.Y. thread (in another forum) for a mud flap made from an office trash can. I may end up tyring it because i need to keep this area in white seen below clean and mud free.

 

one local guy here made them out of diamond plate

 

my wheels sling like a ****, if there was a slick lookin xb1 set I might be down

 

The part number for the Gen1 mudflaps is:

Toyota bB OEM Mud flaps - 08414-52010

 

Some one should start making them, whoever does so efficiently, would make them some FATT CASH!!!!
I need some here soon after I space out my wheels...DAMN!

 

I'd like some too.

I think you can get some generic truck ones and cut and screw them onto the fender liner.

 

I bought a universal set for the rear at PEP Boys because the back of the carton had the scion xb 2005 listed but they did not fit at all. I took them back and got a refund, even though I opened the plastic wrapping.

 

Couldn't one make them fit? There's got to be a lot of leeway for this kind of install.

I'm trying to find a pic of shortbus's flaps. He has them.

 

Nah, they were form fitting and did not fit the form...ha.

I think basic flap type one could be made to fit.

I am just concerned about the rears. That is the real throw up the back problem.

The garbage can flap thread is somewhere around here.