Work was slow, so I vented my fog light cover!
#1
Work was slow, so I vented my fog light cover!
This cost me no dollars, and about an hour... came out pretty good I think. I used a hole saw and drilled out a hole at each end, then cut across the middle with a cut off wheel. I found an Acura MDX rear sub speaker grill, black ABS, in the trash. Also, it happened to have the exact same curve as the cover did. I cut the center grill out of that. To clean up the edge, I sliced off the wiping edge of a wiper blade and fit it around the cut burred edge. Used 3 bond, 2 part epoxy for assembly (that stuff will permanetly glue anything).
At night the headlight leaks light behind the cover, you can see the intake pipe blinging.
At night the headlight leaks light behind the cover, you can see the intake pipe blinging.
#5
Here is my rendition of the intake holes...
I used 3 one inch subwoofer port tubes bought from Ebay. 3 Varad white LED's that were just sitting around wanting to be used. Total time = 1.5 hrs? Not sure, I didn't do everything at the same time. I didn't notice any performance gains but I really like the look of it. I have 3 caps I can put on the tubes just in case of these damn Texas storms.
I used 3 one inch subwoofer port tubes bought from Ebay. 3 Varad white LED's that were just sitting around wanting to be used. Total time = 1.5 hrs? Not sure, I didn't do everything at the same time. I didn't notice any performance gains but I really like the look of it. I have 3 caps I can put on the tubes just in case of these damn Texas storms.
#13
No, I like the way it looks from all angles, just the camera wouldn't pick it up from any other angle or distance than what you see.. The camera doesn't do it justice, was my point... thanks for the positive comments about it!
Thread
Thread Starter
Forum
Replies
Last Post
carid
Exclusive Sponsored Sales
0
01-08-2015 11:33 AM
TheTripleC
PPC: Vehicles
1
01-04-2015 06:46 PM