is the 9006 bulb the replacement for the OEM foglights? has anyone done the installation? opinions welcome...

 

ya they're 9006

install is easy, you can just reach down through the engine bay and pop them in and out - kinda have to get your arms in a funny angle, but it's not too bad, takes about 5 minutes to do both.

all you do is grab on to the back of the bulb and twist, then pull out and remove the wireing harness. then do it in reverse for the new blubs

 

Yup, here's another thread where this was discussed. I JUST swapped mine out. go two of my posts form the bottom and read that. Might help.

https://www.scionlife.com/forums/vie...?p=87593#87593

 

the pass side is so hard, you gotta have skinny arm, the windshield fluid tank is in the way....too me a few mins but it easy

 

It's been two days since I put mine in and my forarms are all bruised! Word of advice, rent the tall skinny kid on your street to put them in.