I have a lot of hush mat. Is there any guid on how to remove door panels and hatch panels? I recently bought a MTX 8500 Dual 12 setup sledge hammer and need to install my hush mat.

 

If I recall, there're two screws per door. Your most obvious one is going to be the door handle (well, not quite... the indentation for you to pull the door shut... I never learned a name for it). The less obvious one is under a plastic cover (under the actual door handle--that is the one to open the door). Cover pops off with a screwdriver nice and easy-like. Apart from that, a little bit of muscle and the panels will pop right off.

 

mtaylor, if you can snap a couple of photos of the process it would be very helpful. there are a few of us who would like do this too.

 

I just yanked off my hatch panel to changed the license plate light. It should pop back with a little force once you align it correctly in place.

 

Should is the key word...