GARAGE1217 HOMEWORK / XD INTAKE
#1
Senior Member
SL Member
Thread Starter
iTrader: (5)
Join Date: Oct 2005
Location: Phoenix, Az
Posts: 6,980
GARAGE1217 HOMEWORK / XD INTAKE
Well took a LONG look at the xD intake system tonight. Basically in a nutshell it SUCKS. The intake sucks are directly from the engine bay close to the radiator on the drivers side through the ugly snorkle like thing.
During my series of tests over the next few days, I will be doing a few tests. See the snorkle is designed to sorta suck air from the drivers side fender, yes there is 0 airflow going into the fender as the drivers bumper vent is blocked just like the passenger. I bet if I open the drivers vent up, I could drop intake temps while moving by at least 30F.
During my series of tests over the next few days, I will be doing a few tests. See the snorkle is designed to sorta suck air from the drivers side fender, yes there is 0 airflow going into the fender as the drivers bumper vent is blocked just like the passenger. I bet if I open the drivers vent up, I could drop intake temps while moving by at least 30F.
#2
places like autozone now carry the components to custom make your own cold-air intake. didnt look at the prices, but its basically a selection of straights and bends with fittings and such, allowing you to piece together an intake. could be worth experimenting with.
now just to get rid of the stock intake manifold...
now just to get rid of the stock intake manifold...
#5
Senior Member
SL Member
Scion Evolution
Join Date: Jul 2004
Location: Soon to be Surprise, AZ
Posts: 248
Originally Posted by pickledchang
places like autozone now carry the components to custom make your own cold-air intake. didnt look at the prices, but its basically a selection of straights and bends with fittings and such, allowing you to piece together an intake. could be worth experimenting with.
now just to get rid of the stock intake manifold...
now just to get rid of the stock intake manifold...
#14
Wow, I'll need to drop by the local Autozone and check it out... sounds like way more fun than buying a pre-fab. How tough was the install? Doesn't seem to me like it would be really tough...
#16
Senior Member
SL Member
Scion Evolution
Join Date: Jul 2004
Location: Soon to be Surprise, AZ
Posts: 248
yes a 90 off the maf then i wanna say a 60 to send it down into the well.so i got the kit then bought a 3" to 3" coupler a 3" to 2.5" coupler that was a biscuit. and 90 bend
#20
Originally Posted by TheJonas53
I think its a load of crap that we have to make an inkake setup. Where are the kits from Injen, AEM, Fujita, ect?