WATS UP GUYS I SEARCHED AND YA TAKES TO LONG HAHA OK HERE IT GOES

IM GOING TO BE GETTING MY XXRS 501 RED THERE 16X8 FRONT AND BACK BUT I NEED SOME HELP ON THE TIRE SIZE I HAVE THE DF210S 2. 5 FRONT AND ABOUT 2 IN THE REAR



HELP HELP HELP

 

ive got the same wheels with the same drop. about to put on some 205/45/16 soon and hopefully rubbing isn't too bad. a little fender rolling should do the trick though. but i'll have to see. let me know what tire size you end up choosing.

 

i was thinking 195/50/16 but not to sure

 

ive got almost the same setup (sportmax 501 16x8+15 on tein coilovers, dropped about the same) and im running 195/50/16
but even with a 195 i was rubbin bad (only in the back) with anything in the back, i even had to adjust my coilovers up.
what i had to do to get rid of the rubbing was -3 camber and roll the rear fenders.
if i turned the strearing wheel all the way i would rub a very tiny bit on the drivers side only and i just did a few taps with a hammer and i went away.

 

this is after tire / wheel install with out camber or rolled fenders



then i did -3 camber


this help alot but it still rubbed if i had stuff in the back and went over a large bump.
i don't like rubbing so i decider to roll the fenders too.

this with the back loaded full, no rubbing, ever