im planning on getting a set of 17x7 +42 offset wheels. im on stock suspension and i was wondering if i will have problems rubbing? because i know they will poke out just a bit.

 

I just posted my review of my wheels and tires after you ... I think you'll be ok. My konigs are 17x7 with 40mm offset and my tires are 215/40-17s. I haven't had any rubbing -- and I haven't been "careful" about turning or bumps or anything.

Chris

 

i have my Sportmax 962s in 17x7 40 offset and 205/40-17s and im on a 2" drop adn i dont rubb
so u's be fine

 

stock size is 15x6 with a 38 offset.
with 17x7 +42 offset you will never rub, even if you go super low.

you can go to a 20 offset without worring about any issues, if you go any further than that, like a 15 offset and a 8" wide wheel than you will start to have problems, but its all easally fixed.

 

u wont rub im runnin 17x7.5 with a 40 offset i had to grind down that nub on the rear passenger side cuz the wieghts were rubing it but u should have no issues with the stock suspension and 7 wide

not sure but the nub might unly be a prob on the 06-06.5

 

what nub?

 

one the back drivers side if u take ur wheel off to ur left on the frame theres a nub its longer on the drivers side and causes issues on 7.5 and wider would get a pic but dont rly feel like taking my wheel off

 

ahhh

 

i know how u feel about club xb lol but nub is mentioned in this thread
http://www.clubxb.com/forums/f24/bad...rims-2082.html

still looking for a pic

 

They won't poke out at all. That offset is higher than the stock offset.

Very little will rub on a stock suspension also, btw.

 

thanks guys a lot!