ok what is tha proper way??...r u spose 2 put them on up all tha way 2 tha top of tha door??...or a lil lower so it touches tha side view mirror??...i wanna kno b4 i put them on...
THANKS!!

 

1st u hav 2 kno how 2 spell.

Put 'em wherever you like them.

 

Yeah not fully sure what you are talking about? Looking at how you think you put them on, are they window visors? If so, there should be a tech article some where on here on how to install them.

 

Use the clips to hold them in place. If you use the clips they will not end up too high or too low. Too high on the window frame and you will not get all the visor you paid the top dollors for, and too low on the frame will result in contact with the mirror assemby housing. Peel back just one inch of the tape covers, and install with the clips. Lastly, pull the tape covers off and push the visor against the frame for a full minute.
But first clean the window frame completely.

 

i put mine on top. it lookd better

 

ima get cf pilars as well...so i think itll look better all tha way up top so theres no cf stickin out above it...but thanks 4 tha help...ill see how it looks when im ready 2 put em on...o BTW what did u clean tha window frame with??

 

There are not many pictures of ESAM visors on this site, so I posted a few in the thread linked below. They are hard to photograph because they are dark, like the rear windows and they reflect light.

See these close-up pictures in this thread:
https://www.scionlife.com/forums/vie...857&highlight=

Use a steady hand when installing, look twice then pull tape cover tab out.
Good luck and post photos of it with that carbon fiber B piller.

 

this is a repost that you even posted in:

search please.

https://www.scionlife.com/forums/vie...m+carbon+fiber

https://www.scionlife.com/forums/vie...er=asc&start=0