Hello y'all! I am planning on getting another set of stocks so I can do a project with them. I want to red out the tails, the JDM look, with the signals and the reflector red. I also want to smoke the remaining parts, the signal and reverse, so it will match better with my black box. Anyone know how I can smoke the parts I want to have smoked?

 

Check the tech section. There are three methods there.

www.scionlife.com/tech

 

check this thread out...https://www.scionlife.com/forums/vie...576&highlight=

Just do it when the day is around 70 to 80 with low humidity. You can pick up Dupicolor Taillight Paint smoke, at any Parts Store carrying Duplicolor. Don't wait more than 1hr between coats and atleast 15min. Hope that helps...PEACE!!!
Jason

 

Thanks for the replies guys! I know that the tech section shows how to do the red out but I wasn't sure if there was a spray that I could use for smoking. Anyone have this done yet? I would like to see pics if so.

 

I should be doing some this week for a friend. I'll try to post finished pics. By the weekend.

 

I can do that in vinyl if I dont already offer that combination .
Bat™

 

Hey Bat, you can do some sort of CF surround?

 

like this?

 

Sure .

Bat™

 

hey bat how about in a color close to envy green

i think smoked with a surround in the green would look sexy

and 1 more thing how about headlights? i was something like 90% see through just so it matches the tails

but im going to wait till i get the headlights i want

 

you can also buy jdm smoke spray off ebay, vinyl is MUCH easier though.

 

werd

 

BloodySunday, that is exactly what I'm talking about. I also want to smoke the signal like you have the reverse too. Can you do something like that Bat? How did you do it BloodySunday? Spray or vinyl? I think it would look awsome on my BSP!

 

got my stuff from bat. they're vinyls.

i am going to smoke the signals as well, pretty soon

 

That's my xbt5 Taillight Overlay . Email me I have 4 others and more on the way .

Bat™

 

Bat, do you have any with the signals smoked? How about install instructions? Is it dificult to do?

 

I can do smoked signals . Pretty straight forward install, just be patient ;). I have an install guide with pics in Maintenance and Care Forum .

Bat™

 

Just checked out your DIY, seems easy enough. What about durability? How long do they last? And most important how much do they cost? As far as signals, I meant the signal part of the tail. I would like the signal and the reverse part of the tail smoked and the rest of the tail to have red out. Es possible?

 

anything is possible. Email me

Bat™

 

Just a few of my Overlays. Again, you can do any colort combo you want .

xbt3:


xbt4:



xbt1:




xbt2:



xbt5:



xbt6: Smoked Redout, pics coming soon!

Bat™