yep. just put them on today. just need to finish the wiring. i'll post up pics asap.(probably tomorrow)

do they fill in the hole completely? or is there a gap?

dude...there is obviously going to be a gap. This is just my rant becauase everytime someone speaks of the famed "IS300" fogs, there is always one or two people who ask the same question. look at the picture of the previous ones and you will see there is absolutely no way to fit it without a gap!

good job. can't wait to see the pics.

hope to see some pics

I was checking out the IS300 bumper today and the spots where the fogs go are just reversed from our tC. That is why you can just reverse the side the fogs go on and they fit. plus, the IS300 has a large gap in it where theirs go. Actually, after looking, the whole mouth of the IS300 is almost the upside down version of the tC mouth.

http://www.wheelmax.com/Wheels/AZA/cars/is-z4.gif
http://memimage.cardomain.net/member_images/4/web/784000-784999/784577_21_full.jpg

http://www.scionlife.com/forums/viewtopic.php?t=43341&highlight=is300+fog

looking good..like it.

Here is a side by side...or top to bottom, if you will.

http://memimage.cardomain.net/member_images/4/web/784000-784999/784577_26_full.jpg
http://memimage.cardomain.net/member_images/4/web/784000-784999/784577_27_full.jpg

very similar indeed :no:

Did anyone see my post about this?

http://www.scionlife.com/forums/viewtopic.php?t=49017&highlight=

sory for the delay in pics. i've been a little busy. pics will be up asap