xB2: unichip
12-02-2012, 03:38 PM
#1
Senior Member
SL Member
Thread Starter
Join Date: Dec 2006
Location: New York
Posts: 2,016
unichip
Used unichip, yes the price is $75+shipping
If you look at the picture one of the grey clip levers is missing.
It threw a cel once and entered the car into limp mode, Im 90% sure its related towards the rear connector being loose(the larger one), the reason i say this is because I rock my KSports on full damp front and rear with a stretched 40 sidewall, and it happened immediately after i hit a sizable bump,
Also one time after hitting a bump it blew the ignition fuze, upon replacing the fuze, it worked just as it used too,
I think it may just need another clip and maybe a bios update not really sure, i purchased it I think for like 280 or so, has the A&B modes(89-91), not trying to make money on it being that I know the next owner will have to most-likely reflash it or buy a clip/make some tie down.
Way better throttle response, mid rpm range had nice gains, all measured on teh butt dyno no real numbers unfortunately, I have the tanabe intake, flowmaster 44 series, and borla dual outs,
email me for a faster reply.
zach sanzo @ gmail dot com
http://postimage.org/image/a5q37s9df/
If you look at the picture one of the grey clip levers is missing.
It threw a cel once and entered the car into limp mode, Im 90% sure its related towards the rear connector being loose(the larger one), the reason i say this is because I rock my KSports on full damp front and rear with a stretched 40 sidewall, and it happened immediately after i hit a sizable bump,
Also one time after hitting a bump it blew the ignition fuze, upon replacing the fuze, it worked just as it used too,
I think it may just need another clip and maybe a bios update not really sure, i purchased it I think for like 280 or so, has the A&B modes(89-91), not trying to make money on it being that I know the next owner will have to most-likely reflash it or buy a clip/make some tie down.
Way better throttle response, mid rpm range had nice gains, all measured on teh butt dyno no real numbers unfortunately, I have the tanabe intake, flowmaster 44 series, and borla dual outs,
email me for a faster reply.
zach sanzo @ gmail dot com
http://postimage.org/image/a5q37s9df/
Thread
Thread Starter
Forum
Replies
Last Post
B_Real45
PPC: Engine / Drivetrain
1
02-23-2015 07:33 PM