new flywheel / clutch install problem
#1
new flywheel / clutch install problem
About 100 miles after getting my new Fidenza UL and ACT Street clutch installed, I started getting CEL for mis-fires. Usually cyclinders 1 , 2 , and 3. Its happened about 4 times in the last 200 miles and Im not sure why. Im figuring it could have something to do with the flywheel being lighter and affecting the starter / timing....... Im running Denzo IK22s. Anyone know of or have had this problem?
#4
yea actually i am. concidering im through 301-304 i figured the type of plugs i was using (ik22s) werent compatible with my set up.... so i switched to ik20s which had a .40 gap, much closer to stock..... but really not difference. On cold start ups, its pretty much the same thing. Youve seen this problem before?
Thread
Thread Starter
Forum
Replies
Last Post
BrokenTC2
Scion tC 2G Drivetrain & Power
4
01-27-2015 03:32 AM
06ScionTc5sp1
Maintenance & Car Care
18
12-21-2014 07:21 AM
JM Auto Racing
Exclusive Sponsored Sales
14
12-19-2014 06:36 PM
TheRedBox
Scion xA/xB 1st-Gen Drivetrain & Power
31
12-02-2003 04:53 PM