Sounds like at this point the running/parking lights in the tails aren't working? Check the #16 10A fuse under the dash.

What about the parking lights in the side of the headlights, are those out to?

Would think the parking/running lights are all on 1 circuit- front markers, tails, and license plates, not certain though.

 

If you still have the original tails, put those back in. Often the Anzo's may have a wiring fault inside them, if they are the LED ones, may be a burned out board causing all sorts of havok.

Heck just this week I saw a Corolla with a melted brake light bulb that fused closed once you hit the brakes, and kept the brake lights on until you turned the car off....

 

ah, I wish I had stock tails. I'm going to the garage now, I'll check all the listed fuses and i'll disconnect the anzo's and see if I can get the license plat lights on with them disconnected. I'll also look at the front parking lights, i'm not sure about them because I had the headlights out and I didn't put all the little parking bulbs back in, just low beam and high beam for now until I figure out this problem. I'll be back on in a bit. Thanks guys.

 

Fixed, found a cut wire. Hmmm. So weird. It was under the c-pillar behind the rear interior piece. What a pain in the ****.

 

^Interesting, good to hear you got it figured out.

 

Glad you found the problem!! Driver's side, did you identify what cut the wire(s)?

 

Yeah, looks like when the interior pieces were taken off and the C-Pillar bar was put in, that either the wire got cut during the install of the C-Pillar bar or Carbon Hatch, or the wire got pinched in one of the clips from popping the interior pieces back in, but I doubt it. I'm thinking more along the lines of the carbon hatch and c-pillar bar install.