After I had the CAI and bulbs installed, the blinker is now blinking really really fast, and I don't know why. How can I fix it to make it go back to normal?

 

Usually that means one of your blinker bulbs is burned out.
Check to see if any of them don't work.

 

All of them work

 

also, i know this doesnt belong in this section but i installed the fujita cai inside a garage while it was raining outside and after the installation i drove it around for a bit andthe CEL turned on immediately . are there any common reasons for this after installing a cai?

 

Check ur MAF. Make sure its plugged in correctly. If it is. Unplug it and see if its dirty maybe.

 

For the blinker check the ground that was relocated under the driver's headlight.

 

sorry for all the questions im pretty new at this. so once i check the ground bolt what do i do with it?

 

what bulbs did you use? i know when i change the tails in my truck to led strips i needed to install a resistor or something because it was drawing a different amount of power and the car thinks it's broken. just an idea

 

yea i installed the 9005 high beam bulbs which use 65 watts instead of the stock 55 watt bulbs is there anything i can do about it? also, i didnt relocate the ground under the driver's headlight

 

9005 silverstar ultra's

 

you touched something you wheren't suppose to cause when i did my high beams, yes there 65 watts as well my blinkers still seemed to blink the same. but yeah check your grounds and you might want to check that all your bulbs in plugged in properly.

 

i converted the 9005 ultras so they would fit in my lows. if i touched something i wasnt suppose to i probably wouldnt be able to fix it huh?

 

there always is a way to fix/repair something. you mean you put the 9005 bulb in the 9006 slot or cut the wires and rewired them vise virsa? well even if the stock wattage is 55 for the low beams you can always add a higher watt and not mess something else up besides your wiring frying. a friend put 85 wattage bulb in his and there bright but hasn't had a problem since summer time.

 

i put the 9005 bulb in the 9006 slot

 

oh then idk, unless you put a LED bulb then that causes it to blink faster, but just try putting a resistor so slow it down which is all i can think of for now.

 

i made a stupid mistake my friends and i forgot to plug in the front signal lights so now its all fixed thanks for the comments tho