rs1 front lip
the sides of the front can be positioned so theat it doesn't look any lower, it lines up perfectly with the oem rockers.


Here's a few more pics of mine too -
https://www.scionlife.com/forums/viewtopic.php?t=163572


Here's a few more pics of mine too -
https://www.scionlife.com/forums/viewtopic.php?t=163572
so when it is installed its not going to be lower then my side casue in those picture they look fine. I'm just afraid that when it get installed on mine it would be lower...did you have to trim it to make it fit?
no trimming. the sides can be attached so everything is the same hight.
I installed mine and I just made sure the bottom edge of the sides of the lip was right against the bottom edge of the sides of the oem bumper. I even tapered the sides in so it matches the curve of the oem rockers.
note the inward curve of the sides as opposed to the image in the post above.
I installed mine and I just made sure the bottom edge of the sides of the lip was right against the bottom edge of the sides of the oem bumper. I even tapered the sides in so it matches the curve of the oem rockers.
note the inward curve of the sides as opposed to the image in the post above.
Thread
Thread Starter
Forum
Replies
Last Post
viciouzgamer
Scion tC 2G Owners Lounge
4
Feb 18, 2015 03:26 PM
ExtremeDimensions
Exclusive Sponsored Sales
0
Dec 18, 2014 04:47 PM
umnitza
Exclusive Sponsored Sales
3
Dec 1, 2014 06:26 PM






