SO i just got my RS1 front lip in today and i dont have time to install it today but i was wondering where all these screws and brackets go:

http://www.flickr.com/photos/4913078...10709/sizes/m/

sorry if its a dumb noob question but i wont be back home til saturday and itd make it easier on me to install it supa fast!!

also i tried to fit it bout the stock grill on the bottom is in the way so how did you guys fix this??

 

I installed mine with 4 screws (2 on each side) and a heavy duty double sided tape.

 

well ya figured that part out...did yours come with those brackets that i have in the picture?? and how did it fit with your bottom grill?

 

Yeah it did, but quite frankly its useless without an instruction. I had to cut that part with a dremel.

 

crap thats what i figured lol...well ill figure it out today. thanks for your help! on the sides like where it wraps around to the wheel well was there a little gap between the lip ad your bump or was it like right on it? cause when i did the mock up there was a little gap..just wondering if its normal?

 

Mine has a gap as well, not a ton but its there. My sideskirts that I got from them are the same way.

 

ohh alright cool, just making sure!! not alone then! haha


How is this lip with your guys's stock grill because mine is in the way so i either gotta take it out or cut that part of the lip..

 

I had to cut about a 1/2" strip off the middle section as well. Before the cut, it was pushing on the lower grill and making gaps.