Hey guys,
I'm running a set of HIDs in my 08 headlights, both headlight harnesses are being used.

I've ordered a set of 3K HIDs for my fogs...then I realized....how will I get these to power up?

I've got APT/VRD fogs and I need some input...

Of course I searched, but after 2 hours, I was hoping I could ask someone who is running something similar.

Thanks SL.

 

Uhm use the fog light connectors. Fog light connectors > Hid Connector (that connects to the ballast) ((they are Pos and Neg wires) Then from the ballast you connect the HID bulb.

 

I got the same setup as you want. Just make sure you use 2 sets of harnesses and you'll be good. Remember if you got a harness that connects to the battery + & - it only uses one oem plug to light up 2 ballast. So lets do the math, 4 ballast + 2 harness = vrd and headlight HIDS!!!!!!

 

You'll need to buy a relay harness since the fogs split off from one connector. I'd suggest getting one for your low beams also just to be on the safe side.

 

Awesome, I appreciate it guys!

I'll post again once it's done...