My girlfriend recently bought me some overlays for my Tailights. I installed them but i am having trouble getting the edges of the overlay to stay down on the light. I have tried using my heat gun to warm the plastic and it works but i slowly comes up. I was wondering if there is a trick that some of yall know about that could help me out. THANKS

 

you are supposed to heat it when you first begin. did you clean off the outer housing before you started?
if you did the heat afterwards you had installed the overlay then it wont stink anymore its like tape when you handle the sticky part it wont stick.


hope this helps

peace

 

yea i sprayed the tailight and the overlay with the alcohol(sp) solution. I followed the directions exactly

 

ill try to post pix later today and thanks for the help mushroomdreamer

 

Ummm.. I think you should have just used water.. I dont think alcohol should be used..

 

the directions said 30%alcohol and 70% H20
heres the link for the directions

http://www.stickercity.com/store/cus...on=tailinstall