so i just bought projectors, ballasts and bulb relay harness and when i hooked up everything the projector lights flickered. i remember that we have drl low beams is this is causing the flicker? If so i hate drls anyway is there a way to remove them?

 

are u in Canada bc if youre not, we dont have drl's

 

haha.. the tC doesn't have DRLs...

 

are you talking about HID's? projectors are a type of light housing. projectors come stock on 08-10'. if your HID kit is just flickering upon start up, that's normal. but if it's flickering continuously when you have it on for a while, then check your connections and make sure everything is tight.

 

^This. Might have to try another ballast.

 

yea i know that we dont have drls that was a mistake i meant the parking light that stays on even when your lights are turned off there basically drls... Anyways i hooked it up to what i thought was the low beam connection it was a redish orangeish cable connector that snaps on to relay harness i bought. Can any one take a pic of the low beam harness connector thing that im supposed to hook the relay harness up to? theres only two i believe theres a black one and the redish one i talked about right?

 

yes im doing a retrofit, I was aiming the projectors and i hooked everything up to turn it on and it flickered continuously it never stayed lit. somethings wrong but i dont know what? its a 2005 scion tc btw

 

If your lights are turned off, no lights on the vehicle are on. Not even the side parking lights. Like said before, it sounds like you have a bad ballast.