Anybody know if it fits the 2010? I do not see why it wouldn't but you never know.

 

there were no changes it will fit just fine.

 

it's the same for all years so it fits.

 

^Yup.

And if not, duct tape.

 

duct tape ftw!!

 

top fits perfect but the bottom game me a little more of a struggle lol.

 

Had the top.. broke some clips when I didn't know what I was doing but it fit great

 

yes it will fit. and where are you getting the grille from im really interested in getting one

 

I will probably be using the website http://www.remixcustom.com/04sctcvrdhou.html

This site has the cheapest price and since I don't buy stuff off ebay, this is where i will probably get it from.

 

http://cgi.ebay.com/ebaymotors/05-06...ht_4177wt_1167

much cheaper there ^^^, same exact grill, nothing different besides the price.

 

I need help.... The bottom grill wont snap in to save my life. Does anyone have a solution to this? otherwise its just hanging there..

 

your lip might be in the way of it, or your trying to snap it in upside down..

 

try dremeling that plasic lip off around the holes for the clips. leave enough plastic so it wont break. the excess was blocking mine from fully snapping in.

 

are these blue bat mobile eyelids?

 

Yes they are Bluebat eyelids. 3-ish years and they still look good.

 

It is right side up and I dont think the lip is affecting it that much to cause it to do that because I felt the clips go past the holes.. it just wasnt snapping in.

 

I realize that I'm using the stock grill for this but for clarification is this the lip you're talking about?

 

It's almost like these grilles are meant to snap in once and be done with. Especially on the bottom grille. I ended up drilling two little holes on the recessed part of the bumper to hold my grille in with tiny zip ties. They'd snap in, but one speedbump, or bumpy ride and they'd be crooked again. I have VRDs, as well.

EDIT : By the way, on your original post of the two VRD grilles, you have the bottom one upside down. I am pretty sure of that. The more curved edge should be at the bottom.

 

LOL yeh I know I flipped it right side up before installing it though. That was just to show them before install. What I did was line the bottom portion of the bumper where the grill slides on with some 3m tape. It seems to be holding now but if by any chance it falls off then I'm just gonna say f*** it.. and just run no grill on the bottom.

 

you can also go ghetto and wedge some masking tape or duct tape or electrical tape..or any kind of tape lol, right on the clips on the bumper and try to snap it in, one of my problems was that the holes on the grill was too big to have the oem bumper clips snap on so i made it a little thicker, it worked fine after that...but then i traded bumpers with someone and snapped most of it on with no problems lmao...guess i had a crappy bumper =x