Will this emblem fit
Thread Starter
Senior Member
SL Member
Joined: Dec 2005
Posts: 122
From: Staten Island, NY
Will this emblem fit
Just wondering if this TRD emblem will fit where the back scion logo is...the one under the 3rd brake light
heres the link to find the picture http://cgi.ebay.com/ebaymotors/TRD-e...QQcmdZViewItem
heres the link to find the picture http://cgi.ebay.com/ebaymotors/TRD-e...QQcmdZViewItem
Senior Member
SL Member
Joined: Feb 2006
Posts: 909
From: York, PA
Sorry, the TRD emblem is not going to fit. I took these measurements when someone was interested in debadging. It's way more than you need to know and it's to late but could still be handy for you in the future...
There's a few different dims that could be important because of the draft angle. I don't have good callipers or a depth gauge so these are approximate and the best I could tell with that badge in the way. If you're making a fillplate, don't trust my numbers! Measure again! Heck, just replace the whole panel! ha!
If someone has better numbers, please correct me! These should be OK within 10 thousandths.
Ellipse degree is somewhere between 40 and 45 degrees. It appears to be a standard ellipse so you can just use the dims below and any program's ellipse tool to get the right shape.
HOLE:
METRIC
Depth: about 3.25mm (can't tell exactly with the badge in the way!)
Recessed: 90.6mm x 61.8mm
Flush: 95.7mm x 64.9mm
ENGLISH
Depth: about .129" (can't tell exactly with the badge in the way!)
Recessed: 3.569" x 2.435"
Flush: 3.769" x 2.558"
BADGE:
METRIC: 90mm x 61mm
ENGLISH: 3.544" x 2.403"
Originally Posted by guitarsurf
There's a few different dims that could be important because of the draft angle. I don't have good callipers or a depth gauge so these are approximate and the best I could tell with that badge in the way. If you're making a fillplate, don't trust my numbers! Measure again! Heck, just replace the whole panel! ha!
If someone has better numbers, please correct me! These should be OK within 10 thousandths.
Ellipse degree is somewhere between 40 and 45 degrees. It appears to be a standard ellipse so you can just use the dims below and any program's ellipse tool to get the right shape.
HOLE:
METRIC
Depth: about 3.25mm (can't tell exactly with the badge in the way!)
Recessed: 90.6mm x 61.8mm
Flush: 95.7mm x 64.9mm
ENGLISH
Depth: about .129" (can't tell exactly with the badge in the way!)
Recessed: 3.569" x 2.435"
Flush: 3.769" x 2.558"
BADGE:
METRIC: 90mm x 61mm
ENGLISH: 3.544" x 2.403"
Thread
Thread Starter
Forum
Replies
Last Post
killahXB2
Scion xB 2nd-Gen Aero & Exterior
4
Mar 29, 2016 04:22 AM