Emanage Setup Question - Berg Jumper Settings?
Thread Starter
Senior Member
SL Member
Joined: Feb 2005
Posts: 2,087
From: St. Louis, MO
Emanage Setup Question - Berg Jumper Settings?
Well, I have the Dezod harness and emanage ready to install. I'm leaving the emanage set to 0 so no changes take effect until I'm ready to tune. However, I need the harness to test the E.S.K.
So, I understand the 3 switches behind the front panel need to be set to 4-2-2
My question is the berg jumpers inside. Emanage instructions state these are for VTEC engines only and not necessary to change if no VTEC present. However, I was told that there are 1 or 2 to change for our VVT-I engines, but they didn't have the info handy.
Would anyone be able to confirm this and if so....which of the 7 jumpers need to be changed? If not, I may have to wait until early next week.
I tell ya, it really sucks Greddy has not updated their info to reflect our cars...
So, I understand the 3 switches behind the front panel need to be set to 4-2-2
My question is the berg jumpers inside. Emanage instructions state these are for VTEC engines only and not necessary to change if no VTEC present. However, I was told that there are 1 or 2 to change for our VVT-I engines, but they didn't have the info handy.
Would anyone be able to confirm this and if so....which of the 7 jumpers need to be changed? If not, I may have to wait until early next week.
I tell ya, it really sucks Greddy has not updated their info to reflect our cars...
Thread
Thread Starter
Forum
Replies
Last Post
TheTripleC
PPC: Vehicles
1
Jan 4, 2015 06:46 PM
gettoastedinthetoaster
Scion xB 2nd-Gen Wheel & Tire
4
Dec 29, 2014 11:39 PM
