I'm replacing all the motor/transmission bushings with Energy Suspension bushings. I got the front mount out easy. Took it to a machine shop and had them press the old one out and put the new one in. Im trying to install it but the bolt hole doesn't line up properly. I have tried raising/lowering the transmission and turning the mount around, but the top bolt hole won't line up. Any suggestions? Please help! In this picture the mount has the bottom two bolts hand tightened.

 

Try sticking a screwdriver in the sleeve and push/pull it to line up. Then on the opposite side tap in the bolt.

 

I got it figured out. Stuck a 2x4 at the ledge of the fixed mount and used a hydraulic jack to move it up 1/4 inch. Fits just fine now.