i read on a thread before but i forgot.....The Greddy SP2 exhaust leans a little towards the right of the bumper. what am i suppose to do to get it centered perfectly?? readjusting the hangers right? a pic of it centered would be nice! thanks

 

bump, wheres the SP2 owners i know there's a lot!

 

Mine is pretty centered. The tip does have a slight "jdm" slant to it tho. I'd just take it to a muffler shop and have em heat and bend the hangers a bit.

...I'm actually chopping the tip off and replacing it with a stainless 4" non-rolled angle cut tip set back flush with the bumper. Bye bye sweet GReddy logo.

 

hmm, thanks..........any other suggestions anyone i know it can be done w/o taking it to a muffler shop

 

you could try bending it yourself. it would take some time and you might have to do a little math but all you should need is a propain trouch and a big a** hammer. what i did for mine was every time i turned off my car after a drive i would get out and step on the exhaust and move it towards the left alittle. eventually it kinda strainened a little better. it is still of center just a tiny bit but i think it looks fine

 

^ I stepped on mine too and pushed at it and what not. its all good now!