ack154

iTrader: (7)

Got the other two from Car Candy Motorsports today. Just have to figure out a time to install them. Maybe next weekend though. Seems to be one of the only times that I'm not doing something else lately...

Anyway... this is what I gots...



Car Candy Motorsports... good people.

Scott8

iTrader: (1)

have fun with the water pump pulley!!!

Hyghgynx

Zoom... Zoom... Zoom. (And NO! Not the Mazda jingle either! ) Good stuff, man.

jsingh

nice!!!
u r like buying something for tC every week
i wish i had that kinda money

t_urbo_C_harged

whats so hard about the water pump pulley???

ack154

iTrader: (7)

I hear it's a bit awkward to get the bolts off. Tight fit and all.

Scott8

iTrader: (1)

the angle of the bolts on the pulley are a beyotch if you have bigger hands.

If you have little girly fingers you'd be fine doing it.....

t_urbo_C_harged

I haven't really looked at it but I am sure it isn't that bad... there is always a tool that fits nice

jetlounge

iTrader: (3)

the water pump pulley was too easy. long open box wrench and long screwdriver to jam it is place is your friend. 10 minutes to swap that one, not even. didn't know what all the fuss was about.

Scott8

iTrader: (1)

then you are better then me at not jamming your knuckles

ack154

iTrader: (7)

Mechanix gloves FTW. Best investment I've made.

Scott8

iTrader: (1)

I have gone through 2 pairs of them. One pair caught on fire when I was grinding the crash bar to make an intercooler fit....

jetlounge

iTrader: (3)

little fingers.

i will say that the alternator was a different story though. getting it out - no prob. busting the nut with my gun, no problem. new pulley on no prob.
getting the alt lined back up perfectly just to thread the retaining bolt through though...seemed like a friggin eternity.

e246

Hit us up with a review after install and let us know what u liked about the pulley kit??