I'm on stechs (you can sorta see them in the first pic)
And they're 17x7 and my tires are 215/45/17

 

Yeah you're right you can see the green springs. I'm lowering in a couple months and am starting to briefly looking around. Any scraping problems?

 

A lot.
Now that I have the lip kit on (lowers it about 1 more inch) I scrape almost everywhere. I just take everything at angles and usually I'm OK, but some spots just can't be avoided.

 

what about before you had the lip kit on there?

 

just curious whats the piping diameter on the hks axle back?

 

I rarely scraped the front cause i still took angles, but if i wasnt careful i would scrape the exhaust

 

Heres a pic of the exhaust with the lip

 

for the bolt on i think its either 2.36 or 2.5

 

love the CF covered exhaust w/ the cf heat shieled. i think the heatshield makes exhaust look clean cuz of the opening but not sure if i'm wanting to spend the money for it

 

anyone want a used agency power titanium exhaust for cheap??!?! pm me

 

does anyone have a custom exhaust thats on the opposite side of the stock position? just imagine where the stock exhaust is and mirror the image over to the left. do you think you'll get better exhaust flow from that?

 

It would be the same.

 

Greddy Evo 2

 

i seen one.. its UGLY! dont do it... but if you have the rear bumper which has exhaust hole on both side.. then you could try it.. but as long as you have that "hole" on the right side... dont.

 

BUMP! keep it going! =D

 

 

Here is my dual exhaust setup.

Done by Precision Muffler and Brake out of Milpitas, CA, Thanks Gabe!

Video: http://vids.myspace.com/index.cfm?fu...deoID=23533290

 

ive always wanted to check this exhaust out but i herd it has some bad drone on the highway. do you get that problem?

 

I love the tanabe concept g......i have no problems it sounds perfect........on the highway and off!