Okey I got My TRD Exhaust Yesterday. What'd someone who installed this use to take out the hangers? They said a HANGER REMOVAL TOOL I'm sure you don't need that or hope not at least.

I haven't taken it apart yet I'm doing that today hopefully someone can reply quick please U'd be a big help .

 

Brute force.

That's about all you need.

 

finally thku all i needed to know

 

WD-40 is what i used and it makes it easier to take off and put back on

 

The hardest part was unbolting the old exhaust it was just wrenched on there. WD-40 soap and sum good old elbow grease worked best once the old exhaust was off which took 25 min it was very easy to install the new one it only took maybe 5 min.




Thanks for the help guys

 

wd40 or soapy water worked in the interior hole.

Then you use locking pliers to snap them off and eliminates any need for elbow grease. You get one part of the plier on the end of the hanger and the other on the back end of the rubber. Set the plier to lock at that point. Then all you need to do is squeeze the plier handles and presto/chango...it's over the barbed end.

 

WD40.

Lots of wiggling.

And correct hand-tools, nothing special.