Rev Hard is building a kit with a ball bearing turbo ran by a Luxury Motorworks I Manage fuel management.

Estimated to be at about 270whp, same stats on the torque at about 8 lbs of boost.

are these numbers POSSIBLE?

 

Moved to PH...

I think one of the kits is about 240whp with about 6psi... so this sounds about right. Assuming that I'm right about the first part.

 

what kinda turbo do you plan on using?

 

yes the numbers are possible

 

Great to hear more companies are coming out with kits, makes things more competitive, good for the consumer(as long as getting a good kit so do not shop by price alone;)

BB turbo is a pretty expensive upgrade for a modest inprovement in reducing lag time. A properly sized turbo will have very little lag, especially hooked up to a large displacement motor with high compression.

Rick

 

T3T4 is what REV HARD is using.. Ball Bearing would create too much torque which will make it too hard to drive... I 'll have a dyno sheet by Thursday hopefully if all goes well...

 

T5? I would check on that again;)



Rick

 

yes GO revhard.

 

t5??