Air/Fuel gauge, where to connect thrid wire??
#1
Air/Fuel gauge, where to connect thrid wire??
Im ready to install Autometer Air/Fuel gauge and of course i know where the Power and Ground wires go. But what about the 3rd wire. The one that actual controls the gauge. Where do I connect that too. Can anybody help me out. I want to see how rich im running with the turbonetics kit.
#2
I'd strongly suggest searching next time. This post will soon get locked.
But to answer your question, Toyota uses a wide-band up front, so using a standard a/f gauge will not work, regardless of how you wire it.
I'd go with a Innovate or AEM wideband gauge. They're both complete kits, and MUCH more accurate.
Innovate Motorsports:
-whitehttp://www.dezod.com/pd_innovate_mot...e_kitblack.cfm
-black http://www.dezod.com/pd_innovate_mot...standalone.cfm
AEM:
http://www.dezod.com/pd_aem_singlechannel_uego.cfm
But to answer your question, Toyota uses a wide-band up front, so using a standard a/f gauge will not work, regardless of how you wire it.
I'd go with a Innovate or AEM wideband gauge. They're both complete kits, and MUCH more accurate.
Innovate Motorsports:
-whitehttp://www.dezod.com/pd_innovate_mot...e_kitblack.cfm
-black http://www.dezod.com/pd_innovate_mot...standalone.cfm
AEM:
http://www.dezod.com/pd_aem_singlechannel_uego.cfm
Thread
Thread Starter
Forum
Replies
Last Post
SkillFreeJake
Scion tC 2G Aero & Exterior
17
07-27-2015 12:34 AM
NewBox06
Scion xA/xB 1st-Gen ICE & Interior
1
02-03-2015 12:36 PM
mattjk
Scion xA/xB 1st-Gen ICE & Interior
121
12-22-2004 10:49 AM