Hey, i'm looking to see if anyone can tell me what size fitting is on the Dezod Spec'd Turbo for the oil feed line?

I know to get it on and off I use a 7/16" wrench because 12mm is too large. I know that both ends are female.

I need a new oil feed line and the one I received today from Dezod is too large.

I need the exact same thing that is show in this pic

http://www.dezod.com/pd_dezod_motors...ion_tc_oil.cfm



Also the same as:


Any help would be greatly appreciated.

 

its 1/8th inch NPT thread.....any parts store will have them.....i got mine from oreilys......bought the oil line from dezod and finished it for about 10 bucks at a parts store.

 

is that your turbo set up. you and me have the same turbo blanket.

 

Just route the line differently. I have a 36" long oil feed line that routes all over the place

 

Yeah my turbo but I still need the oil feed/inlet line.

The pic you sent is the exact same type of line I have and i'm trying to wonder why Dezod sent me something else.

 

That's exactly what I plan on doing if I can find out what size line I need and if I can get it from autozone or advanced auto....they're still building the o'reilys

 

did u call dezod?

 

No, they were closed when UPS dropped off the package last night and they're not open yet.

 

First off you need to rotate that CHRA so that your oil feed is at the top and the oil drain is at the bottom.

The oil feed line is just a teflon 1/8" line or a -4an. Do you have a paintball shop near you? It's the exact same line, telfon with stainless steel braiding.

 

Thanks, I wish you had been around 12 hours ago

I got it all fixed up now

 

I had spoken to him and got him taken care of

 

Definitely!! Looks much better too. I dd have to go to O-reily's to get a 1/8" NPT to 4AN coming off the block but aside from that everything is good. I just have to wait for everything to cool off to get up that nasty oil spill on top of the tranny.

 

The new line setup came with all of the fittings. You should not have had to source anything.

 

I'm not using the same t for the oil block that the kit came with, I think that's the reason why one of the fittings didn't fit and I had to spend the extra $2 :D

All fixed now though

 

cool.