ill get a 1 amp then ill also run a 1 amp fuse? if they make those lol

they dont make em in a blade style...that iv seen anyways but i think iv seen em in a glass sae fuse (older cars from the 80s used em)

just checked but you can get a 1amp blade style (standard not mini or maxi). they are just hard to find.

ok cool ill just get a switch first worry of fuse later...this is pretty neat stuff here i actually like that it doesnt build boos tthat way i can launch at w.e rpm i want and not worry too much bout spinning because of boost...

just a tip though, i noticed that if i stay on 2step/rev limiter too long the ecu goes on the frits and acts like the car is stuck in 2step mode. Its not the fic thats doing it from what i can tell cause the car will go back to normal as soon as the cel stops blinking.

havent had this issue yet....and also ive only gotten the blinking cel once that was the first time i used the 2step now it just stays on idk what the code it nor do i care car aint in limp lol

OMG videos!!!

http://www.youtube.com/watch?v=vv2gKY6LFNM

http://www.youtube.com/watch?v=2YmAS2o_rNs


both vids same settings... usually it sounds like vid 2.... but sometimes just like vid 1

hmmm...could be my wires or relay maybe...idk..havnt played with it since the last vid i put out. good job though mang!!

lol it sounds ok when i had aem ems ____ sounded like shotguns going off lol

it sucks that it wont build up any boost

well so how bout that anti lag next? lol

lulz...thats prolly last on my list of "to do". got too much going on right now. working 6 10's every other week, 4 10's on normal weeks. I love 3 days off but one of those days is for getting stupid crap done (bills, cleaning, shopping, ect). weekends i try my best to reserve for my little girl. nothing works out as planned though.

I thought he said it built a small amount of boost?

2psi

2psi is all I can boost with my wot box and the turbonetics kit. Still on stock mid pipe thoe. Hopefully 3in exhaust will help.

Hi,, AEM Fic wiring Diagram TSX K20A Japan CL7 ??

Thanks~

hi, I signed up to ask a question about the aem 2 step setup you made, I have aem fic on a turbo car and I was just wondering if you thought to hook the relay up to the crank sensor instead of cutting the power to the coils? cutting signal to the crank sensor might make it a more random spark cut which might get more pop pop out the exhaust.

I was going to give it a go anyways, my fuse for the coils is also fuse for the fuel pump so I couldn't do that same way as in the thread

Nice write up!

:)