I know that this question shouldn't be in thos question cause my car isn't turbo just n/a
I went to the dyno today for a 3 time. I was hoping to get it tuned but the tuner was having problems with the emanage. He told me that pnp harnes might be wrong cause it looks like the ecu doesn't respond to any changes he makes. My Tc is automatic and i bought the pnp harnes from dezod. I know that those pnp comes from boomslang and when i checked their website they have different pnp's for an auto and manual. Dezod posts only one kind for 05-06....
Need some advice what might be the issue

 

are the jumpers set properly on the emanage for the tc?

try checking that?

 

hey man is this what you're talking about
http://www.dezod.com/misc_images/tC%20jumpers.jpg

 

^^sure is! did you set those properly! i had mine improperly set before and ran into issues.

 

i didn't even know i need to change anything in emanage. Thanks but i have one more question cause i'm not an electrician so this scheme tells me zero
For example JP3 do i need to connect 1-2 or the red square shows me how to use the jumper. cause i confused now.. If i connects in JP3 the way the red square shows me then i have pin 2-3 connected and not 1-2. The same situation is with JP2.
And what open means. Please don't flame me

 

the red square shows you the position of the jumpers! so you will put it back on in that position.

nah your good cause this is a legit thing. not some dumb.. is this ebay kit gona give me 300whp..

haha just put the jumpers on the management as shown in the picture and you will be good.

once you open the emange you will know what i am talking about.

 

thanks man it's just what i needed . i just opened the emanage and the jumpers where in wrong place. I'm just wondering why the tuner didn't come up with it???

Thanks again man

 

no problem. change them then see what happens.

if not i can take mine apart and send you a pic. you should have it though.

GL!

p.s. b real, i helped this guy... see above.

 

i need to bring this up again.
Ok i changed the jumpers like the diagram on dezod site but now i'm looking at the diagram from greddy.com and that setup is for cars with vtec. The cars with the air folw meter , map sensor should be pinned different that it's on dezod site. i know that i might ask for too much but pics especially for jp3, jp4, jp7 would be a great help. thanks

 

ill take pics in a bit gotta do my laundry anyway and will b right there! give me 30 mins!

 

ok i'm here waiting

 

haha uploading now.

 

heres the bottom:




top:




whole thing:


this should tell you if this was your problem.

lemme know!

 

you're the MAN
NOW I OWN A CASE OF GOOD BEER

 

so were the jumpers wrong?

these should be the same as the dezod jumpers.

 

yep the jumpers were wrong .

 

sweet! let me know how the tuning goes!

 

The diagram is just a generic drawing. PLEASE READ THE WORDS NEXT TO THE JUMPER NUMBER! Those are 100% correct.

 

thanks paul.. i just took pics of mine which i bounced off yours!