The car will start on the stock ECU but will not start with the emanage ultimate. Any ideas as to what can cause this?

If we start the car and let it idle on the stock ECU then switch to the ultimate it will start after warm. The car will not start on the ultimate when cold though. What settings do I need to twak for cold start?

Does anyone have a base map to start with I may use? IF so could you please e-mail it to

prez2510 at hotmail dot com . Thanks.

 

You try the base map off of GReddy site or Dezod Site?

 

yo check your email...i sent you a map

 

make sure ALL of the wires are hooked up properly. MIne was doing the same thing. I contacted greddy and it ended up being my wire for the maf

 

Thanks gingles and others. Will check into it and try the tune ya sent me. Thank you!

 

On mine , at first it was a jumper ( it was set at 5v instead of 12v) . After that ,the base map from greddy sucks. It does not work correctly and i downloaded the map from dezod, it fixed most of the issues. I kept it that way for a bit because i could not find a tunning shop around were i live. Now my turbo's leaking oil from everywhere, they tell me its my seals that have gone bad. I sent it to greddy for inspection and rebuilt if necessary.

 

Sounds like a jumpe setting for sure.

 

Yep! Check jumper 8 (if I recall)

 

I agree also on the jumper settings