Hello all!

I been researching for quite a while now (few weeks so far) in order to find some of the rebuild parts of the S/C. For example, where is a source you can find the Nachi ball bearings nac-6003 that are rated 65k rpm and up? I read just about every page on the S/C thread (https://www.scionlife.com/forums/ann...hp?f=1645&a=19), went on tcsuperchargers.com an even http://www.superchargedscions.com/5601.html ), went to local places like kaman industrial technologies (who do not carry anything like that in speed) which are all great resources but I want to know where I can get them from exactly? I am doing this rebuild on my own an seems like SKF bearings are pretty easy to get but ball bearings that are nachi (or better), I can't find anything over 24k rpm really.

I'm pretty much asking where can I find the Nachi ball bearings nac-6003 or equal to it (if not better)? Prefer somewhere in so cali that I can visit the shop but even internet shops are fine as well.

Rebuild Info
Bearings-
For the impeller shaft bearings
2 Nachi ball bearings nac-6003 (must be speed rated to 65000 RPM)

from the thread https://www.scionlife.com/forums/sho...d.php?t=112896

Appreciate any help!

 

http://www.tcsuperchargers.com/

Try that

 

Where are you located at in Socal?

 

San diego.

I'm starting to wonder if that's even the correct RPM rating. 65000 an not 6500?

 

Called vortex...which was pointless...anyone have any leads ??

 

www.tcsuperchargers.com as stated above should have everything you need.
http://www.superchargedscions.com/ You could email or call them. I am sure either one would carry what you need.

 

i would go by the bearing size which should be 17mm x 35mm x 10mm and then find an angular contact bearing that is speed rated. I believe the stock bearings in the blower were rated for about half of the maximum impeller speed, but i don't remember the exact post where that was discussed.

SKF offers very high speed bearings in various sizes, might want to look through the following link, just taking a quick peek i see at least one 50,000 rpm bearing in there.

http://www.skf.com/files/191342.pdf

 

Thank you! I'll start from there.